Then wash the bag normally in order to remove the solvent. repeat this process until the print is gone. You can use a sharp knife to lift the edges. Wait a little bit and then turn the bag right side out again and start to peel the print off the bag. Turn the cloth bag inside out and after testing to see which one will work the best and doe snot stain, etc., soak the fabric behind the print. Those solvents can be rubbing alcohol, nail polish remover, or some adhesive removers. It may take several wet cloth and iron treatments before the print is completely removed. Use the knife to lift the edges of the print and then grab those edges and peel the print off.Ĭontinue with this process until the print is gone. The next step will be for you to take a sharp knife and begin to scrape the print off the cloth bag. If you delay in this step, you may scorch the cloth. When the cloth between the iron and print is dry, remove the iron and lift the cloth. Now, place your hot iron on the wet cloth and apply enough pressure to ensure the heat is reaching the print. This cloth will protect your iron from any melting particles. Step three has you soaking a towel or some other large cloth and placing it over the print. This will protect the other surfaces from any drips and other damage. next, place a towel between the printed surface and the surface underneath. The first step is to place the bag on a flat surface that won’t be harmed by a hot iron. This process works on clothing so it should work on cloth bags that have prints on them.
0 Comments
Leave a Reply. |